AudioCodes MEDIAPACK VERSION 6.2 Manuel d'utilisateur télécharger pdf (Page 46)

MediaPack BRI Series

User's Manual 46 Document #: LTRT-83702

4. Configure the LAN interface IP address, by performing the following:

a. From the main configuration mode, enter the “ip_interface” mode using the

following command:

192.168.2.1<cfg># ip_interface LAN <CR>

b. Configure the LAN interface static IP, using the following command:

192.168.2.1<if-ip>[LAN]#ipaddress <ip-address> <ip-mask>

<CR>

c. To enable the new configuration, perform one of the following depending on how

you accessed the CLI:

♦ RS-232: type the following commands:

192.168.2.1(if-ip)[LAN]# shutdown <CR>

<Newly assigned IP>(if-ip)[LAN]# no shutdown <CR>

Exit the LAN mode using the following command:

♦ Telnet: the connection to the MediaPack is lost if the LAN interface is

shutdown. Therefore, you must first save the configuration to flash by typing

the following command:

192.168.2.1 # store-running-config

Then reset the MediaPack by pressing on the reset button for more than two

seconds. After the MediaPack restarts, re-access the MediaPack by

repeating steps 1 to 3 using the newly assigned IP address.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 179 180

Pas de commentaire

AudioCodes MEDIAPACK VERSION 6.2 Manuel d'utilisateur Page 46