AudioCodes MEDIAPACK VERSION 6.2 Manuel d'utilisateur télécharger pdf (Page 152)

MediaPack BRI Series

User's Manual 152 Document #: LTRT-83702

6.6.4 Restoring Factory Default Configuration

You can restore the MP-40x to factory default settings using the Web interface, CLI, or

Reset button.

¾ To restore factory default settings using the Web interface:

1. On the main menu bar, click the Load & Save Configuration menu; the ‘Load & Save

Configuration' screen is displayed.

Figure 6-37: Load & Save Configuration Screen

2. Press the “Restore Factory Configuration” button.

¾ To restore factory default settings using the CLI:

 To resore to factorz using the CLI use the following command:

erase startup-config

¾ To restore factory default settings using the Reset button:

1. On the front MediaPack's front panel (refer to Table 4-1), press the reset button

uninterruptedly for more than 15 seconds; the gateway is restored to its factory

settings.

2. If required, assign an IP address to the MediaPack.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 179 180

Pas de commentaire

AudioCodes MEDIAPACK VERSION 6.2 Manuel d'utilisateur Page 152