AudioCodes MEDIAPACK VERSION 6.2 Manuel d'utilisateur télécharger pdf (Page 101)

MediaPack SIP User’s Manual 5. Configuring the MediaPack

Version 4.6 101 June 2005

5.5.8 Configuring the Endpoint Settings

The Endpoint Settings screens enable you to configure port-specific parameters.

5.5.8.1 Authentication

The Authentication Table (normally used with FXS gateways) defines a username and password

combination for authentication for each MediaPack port.

The ‘Authentication Mode’ parameter (described in Table

5-2) determines if authentication is

performed per port or for the entire gateway. If authentication is performed for the entire gateway,

this table is ignored.

Note that if either the username or password field is omitted, the port’s phone number (defined in

Table 5-18) and global password (refer to the parameter ‘Password’ described in Table

5-2) are

used instead.

¾ To configure the Authentication Table, take these 6 steps:

1. Set the ‘Authentication Mode’ parameter to ‘Authentication per Endpoint’.

2. Open the ‘Authentication’ screen (Protocol Management menu > Endpoint Settings >

Authentication option); the ‘Authentication’ screen is displayed.

Figure

5-21: Authentication Screen

3. In the ‘User Name’ and ‘Password’ fields for a port, enter the username and password

combination respectively.

4. Repeat step 4 for each port.

5. Click the Submit button to save your changes.

6. To save the changes so they are available after a power fail, refer to Section

5.9 on page

161.

Table

5-20: Authentication ini File Parameter

Parameter Name in ini File Parameter Format

Authentication_x

Authentication_<Port Number> = <Username>,<Password>

For example:

Authentication_0 = david,14325

Authentication_1 = Alex,18552

Note: Using the sign ‘$$’ enables the user to omit either the username or

the password. For instance, Authentication_5 = $$, 152. In this case,

endpoint 5’s phone number is used instead of username.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 293 294

Pas de commentaire

AudioCodes MEDIAPACK VERSION 6.2 Manuel d'utilisateur Page 101