AudioCodes MediaPack 114 Manuel d'utilisateur télécharger pdf (Page 196)

SIP User's Manual 196 Document #: LTRT-65411

MediaPack Series

¾ To configure the FXO parameters, take these 4 steps:

1. Open the 'FXO Settings' page (Configuration tab > Advanced Applications menu >

FXO Settings page item).

Figure 3-91: FXO Settings Page

2. Configure the FXO parameters according to the table below.

3. Click the Submit button to save your changes.

4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.

Table 3-51: F

XO Parameters Description

Parameter Description

Dialing Mode

[IsTwoStageDial]

Determines the dialing mode for IP-to-Tel (FXO) calls.

 [0] One Stage = One-stage dialing.

 [1] Two Stages = Two-stage dialing (default).

If two-stage dialing is enabled, the device seizes one of the PSTN/PBX

lines without performing any dialing, connects the remote IP user to

the PSTN/PBX, and all further signaling (dialing and Call Progress

Tones) is performed directly with the PBX without the device's

intervention.

If one-stage dialing is enabled, the device seizes one of the available

lines (according to the parameter ChannelSelectMode), and dials the

destination phone number received in the INVITE message. Use the

parameter IsWaitForDialTone to specify whether the dialing must start

after detection of the dial tone or immediately after seizing the line.

Waiting For Dial Tone

[IsWaitForDialTone]

Determines whether the device waits for a dial tone before dialing the

phone number for IP-to-Tel (FXO) calls.

 [0] No = Don't wait for dial tone.

 [1] Yes = Wait for dial tone (default).

When one-stage dialing and this parameter are enabled, the device

dials the phone number (to the PSTN/PBX line) only after it detects a

dial tone.

If this parameter is disabled, the device immediately dials the phone

number after seizing the PSTN/PBX line without 'listening' for a dial

tone.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 389 390

Pas de commentaire

AudioCodes MediaPack 114 Manuel d'utilisateur Page 196