AudioCodes MediaPack 114 Manuel d'utilisateur télécharger pdf (Page 158)

SIP User's Manual 158 Document #: LTRT-65411

MediaPack Series

2. Configure the general parameters according to the table below.

3. Click the Submit button to save your changes.

4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.

Table 3-40:

Routing General Parameters Description

Parameter Description

Add Hunt Group ID as Prefix

[AddTrunkGroupAsPrefix]

Determines whether the device's Hunt Group ID is added as a prefix

to the destination phone number for Tel-to-IP calls.

 [0] No = Don't add Hunt Group ID as prefix (default).

 [1] Yes = Add Hunt Group ID as prefix to called number.

Notes:

 This option can be used to define various routing rules.

 To use this feature, you must configure the Hunt Group IDs (refer

to “Configuring the Endpoint Phone Numbers” on page 181).

Add Trunk ID as Prefix

[AddPortAsPrefix]

Determines whether the port number is added as a prefix to the

called number for Tel-to-IP calls.

 [0] No = Don't add port number as prefix (default).

 [1] Yes = Enable add port number as prefix.

If enabled, the port number (single digit in the range 1 to 8 for 8-port

devices, two digits in the range 01 to 24 for MP-124) is added as a

prefix to the called (destination) phone number.

This option can be used to define various routing rules.

IP to Tel Remove Routing

Table Prefix

[RemovePrefix]

Determines whether the device removes the prefix from the

destination number for IP-to-Tel calls.

 [0] No = Don't remove prefix (default)

 [1] Yes = Remove the prefix (defined in the 'IP to Trunk Group

Routing' table - refer to ''IP to Trunk Group Routing'' on page 163)

from a teleph

one number for an IP-to-Tel call, before forwarding it

to Tel.

For example: To route an incoming IP-to-Tel call with destination

number 21100, the 'IP to Hunt Group Routing' table is scanned for a

matching prefix. If such a prefix is found (e.g., 21), then before the

call is routed to the corresponding Hunt Group, the prefix (21) is

removed from the original number, and therefore, only 100 remains.

Notes:

 Applicable only if number manipulation is performed after call

routing for IP-to-Tel calls (i.e., RouteModeIP2Tel parameter is set

to 0).

 Similar operation (of removing the prefix) is also achieved by

using the usual number manipulation rules.

Source IP Address Input

[SourceIPAddressInput]

Determines the IP address that the device uses to determine the

source of incoming INVITE messages for IP-to-Tel routing.

 [-1] = Not configured (default).

 [0] SIP Contact Header = Use the IP address received in the

Contact header of the incoming INVITE message.

 [1] Layer 3 Source IP = Use the actual IP address (Layer 3) from

which the SIP packet was received.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 389 390

Commentaires sur ces manuels

Pas de commentaire

AudioCodes MediaPack 114 Manuel d'utilisateur Page 158

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs AudioCodes MediaPack 114