AudioCodes MediaPack 114 Manuel d'utilisateur télécharger pdf (Page 188)

SIP User's Manual 188 Document #: LTRT-65411

MediaPack Series

Parameter Description

 This parameter is disregarded if the parameter AlwaysSendToProxy is

set to 1.

Always Use Route

Table

Determines the Request URI host name in outgoing INVITE messages.

 Disable (default).

 Enable = The device uses the IP address (or domain name) defined in

the 'Tel to IP Routing' table (''Tel to IP Routing Table'' on page 160) as

the Req

uest URI host name in outgoing INVITE messages, instead of

the value entered in the 'SIP Group Name' field.

3.4.4.8.3 Configuring the Account Table

The 'Account Table' page allows you to define accounts per Hunt Groups (referred to as

Served Trunk Group) or to a Served IP Group for registration and/or digest authentication

(user name and password) to a destination IP address (Serving IP Group). The Account

table can be used, for example, to register to an Internet Telephony Service Provider (ITSP)

on behalf of an IP-PBX to which the device is connected. The registrations are sent to the

Proxy Set ID (refer to ''Proxy Sets Table'' on page 120) a

ssociated with these Serving IP

Groups. A Hunt Group can register to more than one Serving IP Group (e.g., ITSP's), by

configuring multiple entries in this Account table with the same Served Trunk Group, but

with different Serving IP Groups, user name/password, Host Name, and Contact User

parameters.

Note: You can also configure the Account table using the ini file table parameter

Account (refer to ''SIP Configuration Parameters'' on page 260).

¾ To configure Accounts, take these 5 steps:

1. Open the 'Account Table' page (Configuration tab > Protocol Configuration menu >

Hunt/IP Group submenu > Account Table page item).

Figure 3-88: Account Table Page

2. To add an Account, in the 'Add' field, enter the desired table row index, and then click

Add. A new row appears.

3. Configure the Account parameters according to the table below.

4. Click the Apply button to save your changes.

5. To save the changes, refer to ''Saving Configuration'' on page 209.

Note:

For a description of the Web interface's table command buttons (e.g.,

Duplicate and Delete), refer to ''Working with Tables'' on page 32.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 389 390

Pas de commentaire

AudioCodes MediaPack 114 Manuel d'utilisateur Page 188