AudioCodes MediaPack MP-124 Manuel d'utilisateur télécharger pdf (Page 91)

Configuration Note B. Configuring Lync Server 2013

Version 6.6 91 September 2013

3. Define the listening mode (IPv4 or IPv6) of the IP address of your new PSTN gateway,

and then click Next; the Define the Root Trunk screen is displayed:

Figure B-13: Define the Root Trunk

4. Define a root trunk for the PSTN gateway:

A trunk is a logical connection between a Mediation Server and a gateway uniquely

identified by the combination of the Mediation Server FQDN, Mediation Server

listening port (TLS or TCP), gateway IP and FQDN and gateway listening port.

Note the following:

• When defining a PSTN gateway in the Topology Builder, you must define a root

trunk to successfully add the PSTN gateway to your topology.

• The root trunk cannot be removed until the associated PSTN gateway is

removed.

a. Enter the FQDN of the SBC (e.g., "ACGW2.ilync15.local").

b. In the 'Listening Port for IP/PSTN Gateway' field, enter the SBC listening port (i.e.

5069).

c. In the 'SIP Transport Protocol' field, select the transport type (i.e. TLS).

d. In the 'Associated Mediation Server' field, select the Mediation Server to

associate with the root trunk of this PSTN Gateway.

e. In the 'Associated Mediation Server' port field, enter the listening port that the

Mediation Server will use for SIP messages from the Gateway (i.e. 5066).

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 97 98

Pas de commentaire

AudioCodes MediaPack MP-124 Manuel d'utilisateur Page 91