AudioCodes MediaPack MP-124 Manuel d'utilisateur télécharger pdf (Page 71)

Configuration Note A. Configuring AudioCodes Analog Telephone Adapters (ATA)

Version 6.6 71 September 2013

A Configuring AudioCodes Analog

Telephone Adapters (ATA)

This section describes how to configure the Analog telephone adapter (ATA) device. This

configuration ensures that the ATA routes its calls to the AudioCodes Enhanced gateway.

This section assumes that the ATA device is an AudioCodes MP-1xx series device. For

any other non-AudioCodes ATA devices, refer to the relevant vendor’s instructions.

The steps for configuring the ATA are summarized in the flowchart below:

Figure A-1: Summary of Steps for Configuring the ATA

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 97 98

Pas de commentaire

AudioCodes MediaPack MP-124 Manuel d'utilisateur Page 71