AudioCodes Mediant 2000 Manuel d'installation télécharger pdf (Page 9)

Version 6.0 9 March 2010

Installation Manual 2. Installing the Device

2 Installing the Device

This section describes the device's hardware installation. This includes a physical

description of the device, unpacking the shipped package, and mounting and cabling

procedures.

2.1 Physical Description

The device's chassis is an industrial platform that is 19” wide, 1U high rack-mount and 12”

deep. The device houses a single blade in Slot #1 (the lower slot - form factor 6U PICMG

2.0 single slots) on the front panel. This blade is composed of one or two identical modules:

Gateway-1 and Gateway-2, each containing 240 DSP channels. These modules are fully

independent, each possessing its own Media Access Control (MAC) and IP address, as

well as LED indicators.

This section provides a physical description of the device's front (refer to 'Front Panel' on

page 9) and

rear (refer to 'Rear Panel' on page 10) panels.

2.1.1 Front Panel

The device's front panel is shown in the figure below:

Figure 2-1: Front Panel

Table 2-1: Front Panel Component Descriptions

Item # Label Component Description

1 FAULT

Dual AC power LED. The device's power supply is available in three

configuration options:

 Single universal 100-240 VAC, 1 A max, 50-60 Hz

 Dual-redundant 100-240 VAC, 1.5 A max, 50-60 Hz

 -48 VDC power supply suitable for field wiring applications

- Blade locking screws.

FAIL & ACT Status LEDs.

4 T1/E1 STATUS

E1/T1 Trunk status LEDs (for each of the 1-8 trunks).

ETH (LINK &

ACT)

Ethernet LEDs.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Pas de commentaire

AudioCodes Mediant 2000 Manuel d'installation Page 9