AudioCodes Mediant 2000 Manuel d'installation télécharger pdf (Page 22)

Installation Manual 22 Document #: LTRT-70113

Mediant 2000

2.5 Inserting and Extracting Blades

The device's 1610 blade (form factor 6U PICMG 2.0 single slots) is hot-swappable and

therefore, can be inserted and extracted from a slot while the chassis is under power.

However, it is recommended that you power down the chassis and refer to the notes below

before replacing the components.

Electrical Earthing

Prior to installing a blade in the chassis, connect the chassis to a safety ground

according to the laws and regulations of the country in which the installation is

performed.

Electrical Component Sensitivity

Electronic components on printed circuit boards (PCB) are extremely sensitive

to static electricity. Normal amounts of static electricity generated by clothing

can damage electronic equipment. To reduce the risk of damage due to

electrostatic discharge (ESD) when installing or servicing electronic equipment,

it is recommended that anti-static earthing straps (connected to the rack frame

using an alligator clip) and mats be used. Do not set components down without

protecting them with a static bag.

¾ To insert the blade into the chassis:

1. Gently insert the blade into the device's slot; as the blade is inserted, the black plastic

handles, at both ends of the blade’s front panel, must engage with the chassis. When

the blade is firmly mounted into the correct position inside the chassis, the red plastic

latches within each handle self-lock (this also ensures that the blade is properly

earthed by the chassis).

2. Fasten the screws on the front panel of the blade to secure the blade to the chassis.

¾ To remove the blade from the chassis:

1. Remove the cables (if required on RTM-1610).

2. Unfasten the screws on the brackets at both ends of the panel that secure the blade to

the chassis.

3. Press the red ejector buttons on the two black ejector/injector latches on both ends.

4. Pull on the two ejector/injector latches and gently ease the blade out of the slot.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Pas de commentaire

AudioCodes Mediant 2000 Manuel d'installation Page 22