AudioCodes Mediant 2000 Manuel d'installation télécharger pdf (Page 21)

Version 6.0 21 March 2010

Installation Manual 2. Installing the Device

2.4.5 Connecting the RS-232 Port to a PC

Follow the procedure below to connect the device's serial (RS-232) interface to a PC.

Note: The RS-232 port is available only on the 1-, 2- and 4-span hardware

configurations.

¾ To connect the device's RS-232 interface to a PC:

1. Connect the DB-9 connector on one end of the straight-through RS-232 cable to the

device's RS-232 port (labeled I0I0) located on the front panel (on the 1610 VoP blade).

2. Connect the DB-9 connector at the other end of the cable to either the COM1 or COM2

RS-232 communication port on your PC.

The RS-232 cable connector pinouts are shown in the figure below:

Figure 2-13: RS-232 Connector Pinouts

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Pas de commentaire

AudioCodes Mediant 2000 Manuel d'installation Page 21