AudioCodes MediaPack MP-11x Guide d'installation télécharger pdf (Page 12)

MP-11x

MP-11x 10 Document #: LTRT-61504

2.4.1 Mounting the MP-11x on a Desktop

Attach the four (supplied) anti-slide bumpers to the base of the MP-11x (refer to item #1 in Figure

2-2) and place it on the desktop in the position you require.

2.4.2 Mounting the MP-11x on a Wall

¾ To mount the MP-11x on a wall, take these 4 steps:

1. Drill four holes according to the following dimensions:

¾ Side-to-side distance 140 mm.

¾ Front-to-back distance 101.4 mm.

2. Insert a wall anchor of the appropriate size into each hole.

3. Fasten a DIN 96 3.5X20 wood screw (not supplied) into each of the wall anchors.

4. Position the four oval notches located on the base of the MP-11x (refer to item #2 in Figure

2-2) over the four screws and hang the MP-11x on them.

2.4.3 Installing the MP-11x in a 19-inch Rack

The MP-11x is installed in a standard 19-inch rack by placing it on a shelf preinstalled in the rack.

This shelf can be ordered separately from AudioCodes.

Figure

2-3: MP-11x Rack Mount

Table

2-2: MP-11x Rack Mount

Item # Functionality

1 Standard rack holes used to attach the shelf to the rack

2 Eight shelf-to-device screws

¾ To install the MP-11x in a 19-inch rack, take these 3 steps:

1. Use the shelf-to-device screws found in the package to attach one or two MP-11x devices to

the shelf.

2. Position the shelf in the rack and line up its side holes with the rack frame holes.

3. Use four standard rack screws to attach the shelf to the rack. These screws are not

provided.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

AudioCodes MediaPack MP-11x Guide d'installation Page 12