AudioCodes Mediant 1000 Manuel d'installation télécharger pdf (Page 63)

Version 6.0 63 February 2010

Installation Manual 5. Open Solution Network (OSN) Server Platform

5.1.1 Required Working Tools

The following tools are required for installing the OSN Server module:

 Phillips screwdriver

 Flathead screwdriver

 Wire cutter

5.1.2 Installing the CM Module

The Connection Module (CM) is housed in the device's front panel.

Note: The CM module is applicable only to OSN1.

¾ To install the CM module:

1. On the device's front panel, use a Phillips screwdriver to remove the black metal cover

plate from the slot located below the CPU module.

2. Insert the CM module into the empty slot, with the plain side of the Printed Circuit

Board (PCB) facing up. Ensure the PCB slides into the slot rails, by aligning the CM

with the rails in the slot.

Figure 5-5: Inserting CM Module

3. Gently push the CM module into the slot until it is fully inserted.

4. Using a flathead screwdriver, tighten the module's mounting pins.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 75 76

Pas de commentaire

AudioCodes Mediant 1000 Manuel d'installation Page 63